How can I register my POS with EMVS?
You will be required to configure the UserID and Schema code (allocated to you per POS/SIMS) and replicate to each POS where applicable. Please refer to Where to place EMVS credentials
for more information.
Where to place EMVS credentials?
To place EMVS credentials, in SIMS, go to Support > EMVS > EMVS Client Authorisation. Then, insert System ID and EMVS Credentials. Note: You will require one ID for each SIMS (always MS, as shown in Figure 2). For POS users, you will require an ID ...
Do I need to upgrade my POS?
Upgrading your POS is not necessary. It depends on the specifications of your POS. The specifications for enabling the EMVS module on a POS system can be found in the document attached.
Do I need Internet access on each POS?
An Internet connection is needed to verify EMVS-enabled products. However, if an Internet connection is not available at the time, the Shireburn POS will continue with the sale, and the products will be decommissioned once an Internet connection ...
Do I need to register with EMVS if I am a wholesaler?
Yes, please go to https://www.mamvo.org/on-boarding/endusers/ and register accordingly. You will be required to configure the UserID and Schema code (allocated to you per POS/SIMS) and replicate to each POS where applicable. Please refer to the ...
Does the EMVS module support POYC medicines?
The EMVS module does support the automated verification and decommissioning of POYC products without having to enter these into your Shireburn inventory system. This feature also supports the common practice of pre-preparation of POYC packs for ...